The content of the article:
How to install the air conditioner
You can purchase air conditioning from an installation company. But what if the device is bought from hand? Can I install the air conditioner myself?
How to install a vent air conditioner
DIY air conditioning
Installation do-it-yourself air conditioner not complicated, but you need to know some nuances:
- The entire external part of the equipment, covered with thin plates such as blinds, should be outside and not covered by anything;
- It is advisable to pre-order the windows with vents below. The size of the windows is exactly for the air conditioner. In the summer they are removed and inserted into the air conditioner. Slots around are closed with adhesive tape;
- Before installing the air conditioner with your own hands, you should carefully study the instructions. There are models that should be installed with a slight bias towards the street;
- A drain pipe is attached to the drainage system.
How to install a split air conditioning system
Before installing the air conditioner with your own hands, you need to carefully read the instructions:
- First, let's figure out the wiring. It is advisable to connect the device to an outlet that is not used in any way. Using the control, the phase is determined, and the wires are connected, the machine is connected. The wire stretches along the wall to the place of the future location of the air conditioner. How to install the air conditioner can be found in the manual.
- It is necessary to make four holes in diameter coinciding with the electric cable and three tubes connecting the external and internal blocks.
- To mount the outdoor unit, stock up with large dowels, a punch, a level and special corners for fasteners. Do-it-yourself air conditioning installation is carried out horizontally. The instructions specify the indent from the wall.
- The inner part is hung using the same dowels present in the holder and punch kit. Be sure to check the level and consider the distance to the wall! Decide for yourself whether it is possible to install the air conditioner yourself, should only after studying the instructions.
- A drainage tube is attached, which is led out through one of the holes in the wall, and is connected to the drainage tube from the outer compartment.
- Electric wires are connected using special clamps (pads).
The instruction on how to properly install the air conditioner is not complicated, but now there are works that cannot be carried out independently without special equipment: fastening copper tubes for the coolant, pumping air and pumping the cooler, test run.
